How to Quickly Configure Wireless WPA Connection on Raspberry Pi
The latest version of the Raspbian Linux distro for Raspberry Pi contains a graphical tool for configuring and managing wireless connections, but you can easily set up a wireless connection to a WPA-protected Wi-Fi network without booting into a graphical desktop environment. Assuming that you are using a wireless adapter supported by Raspbian, run the iwconfig command to find out the correct wireless interface (in most cases, it's wlan0). Create then a backup copy of the /etc/network/interfaces network configuration file using the following command:
sudo cp /etc/network/interfaces /etc/network/interfaces.old
Open the file in the nano editor:
sudo nano /etc/network/interfaces
Locate the default configuration of the wlan0 interface which should look something like this:
allow-hotplug wlan0 iface wlan0 inet manual wpa-roam /etc/wpa_supplicant/wpa_supplicant.conf iface default inet dhcp
Replace it with the following profile:
auto wlan0 iface wlan0 inet dhcp wpa-ssid [ESSID] wpa-psk [PASSPHRASE]
Reboot your Raspberry Pi, and it should automatically connect to the configured network.comments powered by Disqus
MSBuild is now just another GitHub project as Redmond continues its path to the light.
Malware could pass data and commands between disconnected computers without leaving a trace on the network.
New rules emphasize collegiality in coding.
Upstart lands in the dust bin as a new era begins for Linux.
HP's annual Cyber Risk report offers a bleak look at the state of IT.
But what do the big numbers really mean?
.NET Core execution engine is the basis for cross-platform .NET implementations.
The Xnote trojan hides itself on the target system and will launch a variety of attacks on command.
Spammers go low-volume, and 90% of IE browsers are unpatched.
Adobe scrambles to release patches for vulnerable Flash Player.